crashtest

2015 / BMW

2015 BMW M3

Safety ratings

2015 BMW M3 4 DR RWD

Not ratedOverall
Not ratedFrontal crash
Not ratedSide crash
Not ratedSide pole
Not ratedRollover
  • Lane departure warningOptional
  • Forward collision warningOptional
  • Electronic stability controlStandard

Crash test videos & photos

No public crash-test footage is available for this vehicle.

Recalls (3)

  • AIR BAGS:SIDE/WINDOWCampaign 24V288000 · 24/04/2024

    BMW of North America, LLC (BMW) is recalling certain 2014-2015 2 Series Coupe (228i, 228i xDrive, M235i), 3 Series Sedan (320i, 320i xDrive, 328i, 328i xDrive, 335i, 335i xDrive, M3, 328d, 328d xDrive), 4 Series Coupe (428i, 428i xDrive, 435i, 435i xDrive, M4), and 2015 4 Series Gran Coupe (428i, 428i xDrive, 435i, 435i xDrive) vehicles. The head air bag inflator may fail at the weld joint, which can cause gas to leak from the inflator or result in an inflator rupture.

    Risk: An inflator that ruptures may cause sharp metal fragments to enter or exit the vehicle, increasing the risk of injury. Additionally, an inflator that leaks gas may only partially inflate during a crash, increasing the risk of injury.

    Fix: Dealers will replace the head air bags, free of charge. Owner notification letters were mailed November 4, 2024. Owners may contact BMW customer service at 1-800-525-7417.

  • POWER TRAIN:DRIVELINE:DRIVESHAFTCampaign 15V782000 · 23/11/2015

    BMW of North America, LLC (BMW) is recalling certain model year 2015-2016 M3 Sedan vehicles manufactured May 30, 2015, to September 2, 2015, 2016 M4 Coupe vehicles manufactured July 3, 2015, to September 11, 2015, and 2015-2016 M4 Convertible vehicles manufactured May 29, 2015, to August 4, 2015. The affected vehicles have a driveshaft with a slip-joint that may not have been filled with grease. As a result, the slip-joint may fail over time.

    Risk: If the slip-joint fails, there would be a loss of power to the rear axle and therefore the vehicle would stop moving, increasing the risk of a crash.

    Fix: BMW will notify owners, and dealers will inspect the driveshaft, replacing it as necessary, free of charge. The recall began on January 14, 2016. Owners may contact BMW customer service at 1-800-525-7417.

  • STRUCTURE:FRAME AND MEMBERSCampaign 16V653000 · 09/09/2016

    BMW North America, LLC (BMW) is recalling certain model year 2016 BMW M2 Coupe vehicles, 2015-2017 M3 Sedan vehicles and 2015-2016 M4 Coupe and M4 Convertible vehicles. During servicing of the rear differential for a prior service action, the rear sub-frame bolts may have been reused instead of being replaced. Reuse of the existing bolts may cause the bolts to loosen.

    Risk: Loose rear sub-frame bolts may adversely affect vehicle handling and control, increasing the risk of a crash.

    Fix: BMW will notify owners, and dealers will replace the rear sub-frame bolts with new bolts, free of charge. The recall began on November 3, 2016. Owners may contact BMW customer service at 1-800-525-7417.

Owner complaints

4
Complaints
0
Crashes reported
0
Fires reported
0
Injuries
0
Deaths

Most-reported areas

  • FUEL/PROPULSION SYSTEM2
  • ENGINE1
  • UNKNOWN OR OTHER1
Read individual complaints (4 most recent)

These are unverified consumer reports filed with NHTSA, shown as submitted.

  • 12/18/2019· ENGINE

    CRANK HUB SPUN TIMING SPROCKET CAUSING VALVES TO IMPACT PISTON AND CATASTROPHIC ENGINE FAILURE. QUOTED MORE THAN $10K OUT OF POCKET TO REPAIR. THIS IS CAUSED DUE TO POOR CRANK HUB DESIGN. CAR COMPANIES HAVE BEEN USING KEYED CRANKHUBS FOR GENERATIONS BUT BMW DECIDED TO NOT USED A KEYED HUB.. THIS IS VERY NEGLIGENT CONSIDERING HOW MANY OF THESE VEHICLES HAVE ENGINE FAILURE DUE TO THIS.

  • 07/28/2020· UNKNOWN OR OTHER

    REAR VIEW CAMERA STOPPED WORKING, SCREEN DISPLAYS "NO SIGNAL". FUSE DID NOT BLOW.

  • 05/14/2022· FUEL/PROPULSION SYSTEM

    Gas tank has a significant leak. This allows for the opportunity to ignite the car putting all persons lives in danger, and effects emissions. Problem has been confirmed by independent Indy shop technician

  • 05/14/2022· FUEL/PROPULSION SYSTEM

    Fuel tank top weld has failed, and is actively leaking fuel. This is likely to cause ignition of the vehicle during use and poses a threat to the lives of passengers and other drivers on the road as well as emissions failure. The failed weld was confirmed by independent Bmw technician. This part is a known failure point, and emission extended warrantee has been established for identical cars of the given make/model/year. The car has limited miles, no structural or cosmetic damage causing this failure. The car is not drivable as it poses a threat to safety.